Operation; Preparations At The Workplace; Charging The Battery; Inserting The Battery - Hilti NPR 032 IE-A22 Operating Instructions Manual

5

Operation

5.1

Preparations at the workplace

CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.3

Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.4

Removing the battery

1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.5

Fitting the crimping / pressing jaws

WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before fitting, changing or removing the crimping / pressing jaws.
Never operate the product without the crimping jaws installed.
In order to ensure correct crimping / pressing and to ensure that the tool functions reliably and safely,
only the crimping / pressing jaws approved by the system manufacturer / tool manufacturer for use
with the tool may be used.
8 English
Printed: 29.10.2018 | Doc-Nr: PUB / 5436576 / 000 / 02