Technical Data; Operation - Hilti NUN 054 IE-A22 Original Operating Instructions

3.5 Items supplied
Crimping / pressing and cutting tool, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.6 Selecting the crimping / pressing die
A table to assist with selecting the type of crimping / pressing die to be used can be found at the end of
these operating instructions.
4

Technical data

Rated voltage
Weight including B22⁄8.0 battery
Crimping time
Max. crimping / pressing force
max. cutting capacity (outside diameter) (NCT J
CUAL cutting jaws)
max. cutting capacity (outside diameter) (NCT J
ACSR cutting jaws)
Max. permissible crimping capacity
Storage temperature
Storage temperature
4.1 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5

Operation

5.1 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
6 English
600 MCM Cu cable
750 MCM Al cable
477 MCM ACSR (Hawk)
guy wire (EHS)
Cu/Al cable
Cu
Al
21.6 V
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
2188463
*2188463*
NUN 054 IE-A22
21.6 V
2.6 kg
(5.7 lb)
≈ 4 s
53 kN
1 1/4 in (33 mm)
1 1/4 in (33 mm)
9/32 in (7 mm)
1 in (25 mm)
600 kcmil
350 kcmil
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)