Table of Contents
Advertisement
I. PRELIMINARY INFORMATION
MODEL NO.: _______________________________________
DATE: _____________________________________________
SERIAL NO. _______________________________________
II. PRE-START-UP (insert checkmark in box as each item is completed)
REMOVE COMPRESSOR TIEDOWN BANDS (SIZES 103,121,150,151 ONLY) PER INSTALLATION INSTRUCTIONS
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED AS SHOWN IN THE INSTALLATION
INSTRUCTIONS
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
CHECK THAT INDOOR AIR FILTERS ARE CLEAN AND IN PLACE
VERIFY THAT UNIT INSTALLATION IS LEVEL WITHIN TOLERANCES LISTED IN THE
INSTALLATION INSTRUCTIONS
CHECK FAN WHEEL AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
CHECK PULLEY ALIGNMENT AND BELT TENSION; REFER TO INSTALLATION INSTRUCTIONS
VERIFY INSTALLATION OF ECONOMI$ER IV HOOD (IF EQUIPPED)
III. START-UP
ELECTRICAL
SUPPLY VOLTAGE
CIRCUIT NO. 1 COMPRESSOR AMPS
CIRCUIT NO. 2 COMPRESSOR AMPS
INDOOR FAN AMPS
TEMPERATURES
OUTDOOR-AIR TEMPERATURE
RETURN-AIR TEMPERATURE
COOLING SUPPLY AIR
REFRIGERANT
REFRIGERANT SUCTION
REFRIGERANT TEMPERATURE SUCTION
REFRIGERANT LIQUID LINE
REFRIGERANT TEMPERATURE LIQUID LINE
VERIFY REFRIGERANT CHARGE USING COOLING CHARGING CHARTS ON PAGES 58-61
(COOLING MODE ONLY)
VERIFY 3-PHASE SCROLL COMPRESSOR IS ROTATING IN THE CORRECT DIRECTION
GENERAL
VERIFY ECONOMI$ER IV MINIMUM VENT POSITION AND CHANGEOVER SETTINGS ARE CONFIGURED
TO JOB REQUIREMENTS (IF EQUIPPED)
Copyright 2005 Bryant Heating & Cooling Systems
All manuals and user guides at all-guides.com
START-UP CHECKLIST
(Remove and Store in Job File)
TECHNICIAN: _________________________________________
BUILDING LOCATION: ________________________________
L1-L2
L1
L1
L1
BOTH CIRCUITS OPERATING
DB
DB
DB
CIRCUIT NO. 1 CIRCUIT NO. 2
PSIG
F
PSIG
F
Printed in U.S.A.
L2-L3
L3-L1
L2
L3
L2
L3
L2
L3
WB
WB
PSIG
F
PSIG
F
CL-1
CATALOG NO. 04-53558002-01
Advertisement
Table of Contents
