Table of Contents
Advertisement
NOTE: To avoid injury to personnel and damage to equipment or
property when completing the procedures listed in this start-up
checklist, use good judgment, follow safe practices, and adhere to
the safety considerations/information as outlined in preceding sec-
tions of this Installation, Start-Up, and Service document.
I. PRELIMINARY INFORMATION
OUTDOOR: MODEL NO. _______________________________
INDOOR: AIR HANDLER MANUFACTURER __________________________________________________________________
MODEL NO. ________________________________ SERIAL NO. ________________________________________
ADDITIONAL ACCESSORIES ________________________________________________________________________________
II. PRE-START-UP
OUTDOOR UNIT
IS THERE ANY SHIPPING DAMAGE?
IF SO, WHERE: ___________________________________________________________________________________________
_________________________________________________________________________________________________________
WILL THIS DAMAGE PREVENT UNIT START-UP?
CHECK POWER SUPPLY. DOES IT AGREE WITH UNIT?
HAS THE GROUND WIRE BEEN CONNECTED?
VERIFY GROUND INTEGRITY WITH CONTINUITY TEST.
HAS THE CIRCUIT PROTECTION BEEN SIZED AND INSTALLED PROPERLY?
ARE THE POWER WIRES TO THE UNIT SIZED AND INSTALLED PROPERLY?
CONTROLS
ARE THERMOSTAT AND INDOOR FAN CONTROL WIRING CONNECTIONS MADE AND CHECKED? (Y/N) __________
(Thermostat wiring must be made directly to the fan coil unit)
ARE ALL WIRING TERMINALS (including main power supply) TIGHT?
HAS CRANKCASE HEATER BEEN ENERGIZED FOR 24 HOURS?
INDOOR UNIT
HAS WATER BEEN PLACED IN DRAIN PAN TO CONFIRM PROPER DRAINAGE?
ARE PROPER AIR FILTERS IN PLACE?
HAVE FAN AND MOTOR PULLEYS BEEN CHECKED FOR PROPER ALIGNMENT?
DO THE FAN BELTS HAVE PROPER TENSION?
HAS CORRECT FAN ROTATION BEEN CONFIRMED?
PIPING
ARE LIQUID LINE SOLENOID VALVES LOCATED AT THE INDOOR COILS AS REQUIRED?
HAVE LEAK CHECKS BEEN MADE AT COMPRESSOR, OUTDOOR AND INDOOR COILS, TXVs
(Thermostatic Expansion Valves), SOLENOID VALVES, FILTER DRIERS, AND FUSIBLE PLUGS WITH
A LEAK DETECTOR?
LOCATE, REPAIR, AND REPORT ANY LEAKS.
HAVE LIQUID LINE SERVICE VALVES BEEN OPENED?
HAVE SUCTION LINE SERVICE VALVES BEEN OPENED?
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
START-UP CHECKLIST (569J)
(REMOVE AND USE FOR JOB FILE)
(Y/N) __________
SERIAL NO. ________________________________________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
(Y/N) __________
Form No: II569J-16-28-02
CL-1
Replaces: II569J-16-28-01
Advertisement
Table of Contents
