Rear Panel Jacks - Samsung ST-43T6P Owner's Instructions Manual

Y N T V
O U R E W

Rear Panel Jacks

Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Because there are two sets of input jacks, you can connect two different A/V components
(i.e., a VCR and a DVD, 2 VCRs, etc.)
For more information on connecting equipment, see pages 2.1 – 2.8.
ΠANTENNA terminals
Two independent cables or antennas can be
connected to these terminals. Use ANT-A and
ANT-B terminals to receive a signal from
VHF/UHF antennas or your cable system. Use
the ANT-A OUT terminal to send the signal being
received by the ANT-A terminal out to another
component (such as a Cable Set Top Box). The
PIP channel can be received only when a signal
source is connected to ANT-A.
´ S-VIDEO INPUT jack
Connect to an S-VHS VCR or DVD player.
ˇ VIDEO INPUT jacks
Connect to the video output jacks of VCRs, DVD
players and similar devices (Two sets are avail-
able: Video1 and Video2).
¨ AUDIO INPUT jacks
Connect to the audio output jacks of VCRs, DVD
players and similar devices.
ˆ AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video input jacks of a
recording VCR.
Note: The monitor out does not operate in DVD
or DTV mode.
Ø COMPONENT 1(480i, 480p)
INPUT jacks
Connect a source that outputs 480i/480p Y,P
P signals, such as a DVD Player.
R
∏ COMPONENT 2(480p)
INPUT jacks
Connect a source that outputs 480p Y,P
signals, such as a DTV Set-Top Box.
" SURROUND OUT
Connects to a (optional) rear-surround amp:
Surround Left, Surround Right and Center.
C
and
B
and P
B R
1.4
O : Y N TV
HAPTER NE OUR EW