Setting Up Your Remote Control To Operate Your Cable Box - Samsung ST-43T6P Owner's Instructions Manual

S
P E C I A L

Setting Up Your Remote Control to Operate Your Cable Box

1
Turn off your cable
box.
2
Press the MODE button and make sure that the Cable
LED is illuminated.
3
On your Samsung remote control, press SET.
4
Enter 3 digits of the cable box code listed below for your brand of
cable box.
5
Press Power. Your cable box should turn on. If your cable box turns
on, your remote control is now "set up" correctly.
6
Once your remote control is set up, press the MODE button any time
you want to use the remote to operate your cable box.
4.21
C F : S
HAPTER OUR PECIAL
F
E AT U R E S
F
EATURES
The remote control has four
"modes": "TV," "VCR," "CABLE"
and "DVD."
Press the "MODE" button to switch
the remote control to the "Cable"
mode.
Make sure you enter 3 digits of
the code, even if the first digit is a
"0." (If more than one code listed,
try the first one.)
If your cable box does not turn
on, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
particular brand of cable box. (If no
other codes are listed, try each cable
box code, 000 through 077.)
When your remote control is
in the "CABLE" mode, the volume
buttons still control your TV' s vol-
ume. Also, the VCR control buttons
(PLAY, PAUSE, etc.) will still operate
your VCR.