Storing Channels In Memory (Automatic Method); Adding And Erasing Channels (Manual Method) - Samsung ST-43T6P Owner's Instructions Manual

O
P E R AT I O N

Storing Channels in Memory (Automatic Method)

1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~2
on previous page.
Press the Menu button.
Move the joystick down to
select "CHANNEL", then
press the joystick to enter.
2
Move the joystick down
to select "Auto Program",
then press the joystick to
enter.
3
The TV will begin
memorizing all of the
available channels.
After all the available
channels are stored, the
Auto program menu reap-
pears. Press the Menu
button to exit.
Note: Channel auto program does not function when the V-chip is active.

Adding and Erasing Channels (Manual Method)

1
Use the number buttons to directly select the channel
that will be added or erased.
2
Press the Add/Erase button:
Repeatedly pressing this button will alternate between
"Channel added" and "Channel erased."
Press the Menu button to exit.
You can view any channel (including an erased channel) by using the number
buttons on the remote control.
The TV automatically cycles
through all of the available chan-
nels and stores them in memory.
This takes about one to two min-
utes.
Move the joystick to the right at
any time to interrupt the memo-
rization process and return to the
Setup menu.
C T : TV O
HAPTER HREE
3.9
PERATION