Table of Contents
Advertisement
Your New Wide TV
Front Panel LED Indicators
The three lights on the front panel indicate the status of your TV.
Indicator Light Key
: Light is On
: Light is Blinking
: Light is Off
Indicator Light
Indication
Timer Lamp Temperature
Normal operation.
On time or off time is set.
On time or off time is set. Normal operation.
Lamp is warming up. The normal picture comes on in about 30 seconds.
Air vent cover at the rear of the TV is not properly installed.
Inside temperature of the TV is too high. Turn the TV off and clean the
air vent cover on the back of the TV. Turn the TV on after 1 hour.
Lamp inside the TV needs to be replaced.
• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
• The TV has a fan to keep the inside lamp from overheating. You'll occasionally hear it working.
10
TIMER
POWER
TEMP.
Rear Panel Jacks
Use the rear panel jacks to connect components such as a VCR or laserdisc player.
You can connect two different components such as two VCRs, Set-Top Box and a DVD player etc.,
because there are two sets of video input jacks and one set of component video input jacks on the rear
panel of your TV. For more information, please see "Connections".
DVD
Y
ANT-A
P
b
MONITOR
ANT A-OUT
P
OUT
r
VIDEO
2
L
ANT-B
S-VIDEO 1
S-VIDEO 2
VIDEO
1
R
V
L
R
ΠANTENNA terminals
Ø DTV INPUT jacks (Y, P
Two independent cables or antennas can be connected to these termi-
nals. Use ANT-A and ANT-B terminals to receive a signal from
VHF/UHF antennas or your cable system. Use the ANT A-OUT termi-
nal to send the signal being received by the ANT-A terminal out to
another component (such as a Cable Set Top Box).
∏ PC AUDIO INPUT jacks
The PIP channel can be received only when a signal source is
connected to ANT-A.
´ S-VIDEO INPUT jacks
" DVI (Digital Video Interface) jack
Connects an S-Video signal from an S-VHS VCR or DVD player.
ˇ VIDEO/AUDIO INPUT jacks(VCR1, VCR2)
' PC VIDEO INPUT jack
Connect video/audio signals from external sources, such as a VCR or
DVD players.
˝ RS-232C jack
¨ VIDEO/AUDIO MONITOR OUTPUT jacks
Sends a video signal from the TV to an external source, such as a
VCR.
ˆ DVD INPUT jacks (Y, P
, P
L, R)
b
r,
Use these jacks to connect the component video/audio signals from a
DVD player when using the component video input jacks.
Note: Only 480i format is supported in its original format.
DTV1
DTV2
PC AUDIO
DVI
PC
RS-232C
L
R
, P
L, R)
b
r,
Receives the DTV video/audio signals from a set top box.
Note: Only 480p, 720p and 1080i formats are supported in their
original formats.
Connect these to the audio-output jacks on your PC.
Receives the digital signals from a set top box or PC etc.
Connect to the video output port on your PC.
Only for servicing.
11
Advertisement
Table of Contents
