Table of Contents
Advertisement
PLATINUM
Series User's Guide
TM
4.3
Excitation Voltage (INIt > ECtN) .................................................................................................. 27
4.4
Communication (INIt > CoMM) ................................................................................................... 28
4.4.1
Protocol (INIt > CoMM > USb, EtHN, SER > PRot) ............................................................... 28
4.4.2
Address (INIt > CoMM > USb, EtHN, SER > AddR) ............................................................... 29
4.4.3
Serial Communications Parameters (INIt > CoMM > SER >C.PAR) ..................................... 29
4.5
Safety Features (INIt > SFty) ........................................................................................................ 31
4.5.1
Power On Confirmation (INIt > SFty > PwoN) ..................................................................... 31
4.5.2
Operating Mode Confirmation (INIt > SFty > oPER) ............................................................ 31
4.5.3
Setpoint Limits (INIt > SFty > SP.LM) ................................................................................... 31
4.5.4
Loop Break Timeout (INIt > SFty > LPbk) ............................................................................. 32
4.5.5
Open Circuit (INIt > SFty > o.CRk)........................................................................................ 32
4.6
Manual Temperature Calibration (INIt > t.CAL) .......................................................................... 32
4.6.1
No Manual Temperature Calibration Adjustment (INIt > t.CAL > NoNE)............................ 33
4.6.2
Manual Temperature Calibration Offset Adjustment (INIt > t.CAL > 1.PNt) ...................... 33
4.6.3
4.6.4
Temperature Ice Point Calibration (INIt > t.CAL > ICE.P) .................................................... 33
4.7
Save Current Configuration for All Parameters to a File (INIt > SAVE) ....................................... 33
4.8
Load a Configuration for All Parameters from a File (INIt > LoAd) ............................................. 34
4.9
Display Firmware Revision Number (INIt > VER.N) ..................................................................... 34
4.10
Update Firmware Revision (INIt > VER.U) ................................................................................... 34
4.11
Reset to Factory Default Parameters (INIt > F.dFt) ..................................................................... 34
4.12
Password-Protect Initialization Mode Access (INIt > I.Pwd) ....................................................... 34
4.13
Password-Protect Programming Mode Access (INIt > P.Pwd) .................................................... 34
5.
Reference Section: Programming Mode (PRoG) ................................................................................ 35
5.1
Setpoint 1 Configuration (PRoG > SP1) ....................................................................................... 35
5.2
Setpoint 2 Configuration (PRoG > SP2) ....................................................................................... 35
5.3
Alarm Mode Configuration (PRoG > ALM.1, ALM.2)................................................................... 36
5.3.1
Alarm Type (PRoG > ALM.1, ALM.2 > tyPE)......................................................................... 36
5.3.2
Absolute or Deviation Alarm (PRoG > ALM.1, ALM.2 > tyPE > Ab.dV) ................................ 37
5.3.3
Alarm High Reference (PRoG > ALM.1, ALM.2 > tyPE > ALR.H) .......................................... 37
5.3.4
Alarm Low Reference (PRoG > ALM.1, ALM.2 > tyPE > ALR.L) ............................................ 37
5.3.5
Alarm Color (PRoG > ALM.1, ALM.2 > A.CLR) ...................................................................... 38
Introduction
Omega Engineering | www.omega.com
4
Advertisement
Table of Contents
