Omega CN16Pt User Manual page 20

PLATINUM Series User's Guide
TM
Level Level Level
2 3 4
oN.oF
ALM.1
ALM.2
RtRN
RE.oN
SE.oN
CyCL ____
RNGE 0–10
0–5
0–20
4–20
0–24
oUt2
oUt3
PId.S ACtN RVRS
dRCt
A.to ____
AUto StRt
GAIN _P_
_I_
_d_
%Lo ____
%HI ____
AdPt ENbL
dSbL
RM.SP oFF
oN 4–20
Level Level
5 6
ACtN RVRS Off when > SP1, on when < SP1
dRCt Off when < SP1, on when > SP1
dEAd ____ Deadband value, default = 5
S.PNt SP1 Either Setpoint can be used of on/off, default is SP1
SP2 Specifying SP2 allows two outputs to be set for heat/cool
Output is an Alarm using ALM.1 configuration
Output is an Alarm using ALM.2 configuration
Process value for oUt1
Rd1 ____
oUt1 ____ Output value for Rd1
Rd2 ____ Process value for oUt2
oUt2 ____ Output value for Rd2
Activate during Ramp events
Activate during Soak events
PWM pulse width in seconds
Analog Output Range: 0–10 Volts
0–5 Volts
0–20 mA
4–20 mA
0–24 mA
oUt2 is replaced by output type
oUt3 is replaced by output type
Increase to SP1 (i.e., heating)
Decrease to SP1 (i.e., cooling)
Set timeout time for autotune
Initiates autotune after StRt confirmation
____ Manual Proportional Band setting
____ Manual Integral Factor setting
____ Manual Derivative Factor setting
Low clamping limit for Pulse, Analog Outputs
High clamping limit for Pulse, Analog Outputs
Enable fuzzy logic adaptive tuning
Disable fuzzy logic adaptive tuning
Use SP1, not remote Setpoint
Remote analog Input sets SP1; range: 4–20 mA
Note: This submenu is the same for all RM.SP ranges.
RS.Lo ____ Min Setpoint for scaled range
IN.Lo ____ Input value for RS.Lo
RS.HI ____ Max Setpoint for scaled range
Complete Menu Structure
Notes
Omega Engineering | www.omega.com
20