Bilge Pump - Quicksilver 605BR Owner's Manual

Quicksilver® 605BR — System & Component Overview and Operation
Fresh Water System
Disinfect the Fresh Water System
The following is a recommended procedure to disinfect the fresh water system:
1. Flush the entire system thoroughly by allowing potable water to flow through it.
2. Drain the system completely.
3. Fill the entire system with an approved disinfecting solution. Check with your dealer for
recommended products, and follow the manufacturer's instructions.
4. After disinfecting, drain the entire system.
5. Flush the entire system thoroughly several more times with potable water.
Maintenance
Maintenance of the fresh water system will require you to check the fittings and hoses to make sure
that there are no leaks. Before the winter season, the fresh water system must be completely
drained to avoid damage.

3. Bilge Pump

Your vessel is equipped with a single bilge pump located in the aft section of the boat. Access to the
bilge pump is via the motorwell access plate. The bilge pump is rated at 500 GPH, and is activated
automatically by a built in mercury free float switch when the water in the bilge reaches a
predetermined level. You can also manually operate the bilge pump at the console by pressing the
bilge pump switch at the helm.
Inspect the bilge pump intakes and keep them free of dirt or material which may impede the flow of
water through the pump. To clean the pump strainer, depress the lock tabs on both sides of the
pump and lift the pump motor.
Water tank fill
Water tank fill hose
Water tank
Water tank vent hose
Water tank vent
16
Water tank to water pump hose
Water pump strainer
Water pump
Transom shower hose
Transom shower