- Record Stream to SD Card:
When you check this item, the alarm-triggered recording will be stored on your Micro SD/SDHC card when
network failure is detected.
The pre-trigger buffer recording function allows users to check what happened to trigger the alarm. The pre-
trigger buffer time range is from 1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after the alarm is triggered. The setting range is from 1
to 99999 seconds.
Select <Upload while trigger is active> to record the triggered video until the trigger is turned off.
NOTE: Please make sure that the local recording (with Micro SD/ SDHC card) is activated so that this function can
be implemented. See section 9.14. 'Recording (on Camera)' for further details.
- Send Message by FTP:
The Administrator can select whether to send an alarm message by FTP when Network Failure is detected.
- Send Message by E-Mail:
The Administrator can choose to send an alarm message by E-Mail when Network Failure is detected.
Save :
After completing all the settings mentioned above, please click on the Save button to save all the settings in this
page.
English
45