Grundig GCI-K1607B Owner's Manual page 43

When motion is detected, the signals will be displayed in the Motion window as shown below:
The detailed settings of Motion Detection are described as follows:
Motion Detection :
In each set of the Motion Detection Setting, the default setting for the Motion Detection function is <Off>. Enable
this function by selecting <On>. Users can also activate the function according to the schedule previously set in
the <Schedule> setting page. Select <By schedule> and click <Please select...> to choose the desired schedule
from the drop-down menu.
Motion Detection Setting :
Users can adjust various parameters of Motion Detection in this section.
- Sampling pixel interval [1-10]:
The default value is 1. If the value is set as 3, it means that within the detection region, the system will take one
sampling pixel for every 3 pixels by each row and each column (please refer to the figure below).
- Detection level [1-100]:
The default level is 10. This item is to set the detection level for each sampling pixel; the smaller the value, the
more sensitive the detection is.
- Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are detected as changing, the system will
detect motion. The bigger the value, the more sensitive the detection is. Meanwhile, when the value is bigger, the
red horizontal line in the motion indication window will be accordingly lower.
- Time interval (sec) [0-7200]:
The default interval is 10. This value is the interval between each detected motion.
Triggered Action (Multi-option) :
The Administrator can specify alarm actions that will take place when motion is detected. All options are listed as
follows:
- Enable Alarm Output:
Check this item and select the predefined type of alarm output to enable alarm relay output when motion is
detected.
English 41