Grundig GCI-K1607B Owner's Manual page 40

The <Pre-trigger buffer> recording function allows users to check what happened to trigger the alarm. The pre-
trigger buffer time range is from 1 to 20 frames.
On the other hand, the <Post-trigger buffer> is for uploading a certain amount of images after the alarm input is
triggered. The post-trigger buffer time range is from 1 to 20 frames.
Check the box <Continue image upload> to upload the triggered images during a certain time or keep uploading
until the trigger is off.
- Select <Upload for __sec> and enter the duration in the blank. The images of the duration will be uploaded by
E-Mail when the alarm input is triggered. The setting range is from 1 to 9999 seconds.
- Select <Upload while trigger is active> to keep the images being uploaded via E-Mail while the trigger is active,
i.e. until the alarm is stopped.
Set the Image frequency as the upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE: Make sure SMTP or FTP configuration has been completed. See section 9.5. Mail and 9.6. FTP for further
details.
- Send HTTP notification:
Check this item, select the destination HTTP address, and specify the parameters for event notifications when an
<Alarm> is triggered. As soon as an alarm is triggered, the notification will be sent to the specified HTTP server.
For instance, if the custom parameter is set as "action=1&group=2", and the HTTP server's name is
"http://192.168.1.200/admin.php", the notification will be sent to the HTTP server as
"http://192.168.1.200/admin.php? Action=1&group=2" when an alarm is triggered.
38 English