Table of Contents
Advertisement
5.11 Adjusting the Back Angle and Back Depth
1.
Loosen the screws A in the mounting pin assembly of both clamp
bodies B.
2.
Adjust the position of the mounting pin assembly via the slots in the
clamp bodies to achieve the desired back depth (Detail A) and back
angle (Detail B).
Angle and depth adjustments must be made equally on
both sides.
3.
Tighten the screws on both clamp bodies to secure the back into
position.
Detail A
B
A
A
Part No. 1171914
5.12 After Installation
1.
2.
5.13 Removing the Back Cushion
1.
2.
Detail B
27
5 QUICK RELEASE DUAL MOUNT
Verify that all mounting hardware is fully tightened.
Ensure that the back is securely attached to the wheelchair.
Unlock the levers on the adjustable mounting brackets.
Lift the back cushion up and forward to disengage it from the
mounting pins.
1
2
Invacare® Matrx® MX1
Advertisement
Table of Contents
