Installation And Connection; Selecting The Location - Atag BCD75178DF Instructions For Use Manual

Installation and connection

Selecting the location

• Do not place the appliance near a source of heat, such as a gas cooker, radiator or boiler, etc.,
and do not expose it to direct sunlight.
Description
Extended temperate
Temperate
Subtropical
Tropical
WARNING!
Do not place the appliance in a room where the temperature can fall below the lowest permitted
ambient temperature: the appliance may not work properly!
WARNING!
Do not place the appliance in a room where the temperature can fall below 5 °C: the appliance
may not work properly or become defective!
WARNING!
The appliance is not suitable for outdoor use and it may not be exposed to rain.
• The appliance must be placed at a distance of at least 5 cm from an electrical or gas cooker
and at least 30 cm from a radiator or heater. An insulation panel must be fitted when these
distances cannot be kept.
• The appliance must be placed at a distance of about 5 cm from the wall, back and sides of a
cupboard. A kitchen cupboard above the refrigerator must have a gap of at least 5 cm between
the back of the cupboard and the wall. This is needed to make sure that there is sufficient cooling
air for the condenser.
• The plug of the installed appliance must remain accessible!
10
• Place the appliance in a dry and well aired room. The permitted
ambient temperature range for the appliance depends on the
appliance's climate class, which is shown on the type plate.
Class Ambient temperature range °C
SN
N
ST
T
+10 to +32
+16 to +32
+16 to +38
+16 to +43
Relative humidity
≤75%