Faema CARISMA S-1 Use And Installation page 44

14. Setting the boiler temperature/steam keys
Version: Carisma A Quicksteam (wands: water - Quicksteam)
In the Quicksteam versions, the programming phase
includes setting the boiler temperature and the temperature
for the steam keys:
1
To access the programming
menu, press and hold the
center key OK for at least
4 seconds.
5
Use the +/- keys on the side to set
the stop dispensing temperature
key
The presence of reference marks
below the temperature follows
this logic:
1 MARK Setting phase
2 MARKS Setting phase
R e f e r e n c e
Mark
3 MARKS Setting phase
Stop
temperature
8
Press the center key OK and proceed to set the hot
steam key.
Use the +/- keys on the side to set
the stop dispensing temperature
Instant boiler temperature
2
SET
*
Set temperature
An asterisk and the word
SET appear on the display.
Stop temperature
Dispensing
Start air temperature
Stop air temperature
10
Confirm and exit the
programming menu by
pressing the center key OK.
3
SET
*
Use the +/- keys on the
side to set the boiler
temperature (value with
large characters).
6
Start air
temperature
Press the center key OK
and use the +/- keys on
the side to set the start air
temperature (compressor
working).
9
Start air
temperature
Press the center key OK and then use the +/- keys on
the side to set the start air and stop air temperatures.
The hot steam key must be set at the same temperature.
14 EN
4
Press the center key OK to
pass to the phase for setting
the frothed steam key.
Note: Each time the center
programming key OK is
pressed, the next screen
appears.
7
Stop air
temperature
Press the center key OK
and use the +/- keys on
the side to set the stop air
temperature (compressor
not working).
Stop air
temperature