atd models ATD007 Instruction Manual page 2

1. Detach Wall A and place it face down on your work surface. Then fold the tabs over on themselves
and glue. Repeat this step for Wall B.
Apply firm pressure on the tabs until the glue is semi cured to stop them from lifting.
i
2a. Detach Wall E and glue it to Wall A.
The window openings on Wall E are slightly
i
smaller than the window openings on Wall A.
3a. Locate the Glazing Sheet, cut out the windows and then glue them into position, as per the
illustation below.
Ensure that you cut out the glazing along the outer black lines. This will allow an overhang on each
i
piece of glazing making them easier to glue into position.
3b. Detach one of the doors (we've given two
colour options) and glue it to the inside of
Wall A.
We have scored the doors giving you the
i
option to have them open by carefully
running the blade across the score lines.
2b. Detach Wall F and glue it to Wall B.
The window openings on Wall F are slightly
i
smaller than the window openings on Wall B.