Advertisement
Available languages
Available languages
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off:
press the on/off switch and release it again
Attention!
!
Only press the lock-on button when using a stand. In case
of every stop of the machine, the lock-on button has to be
released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
The hand-held drilling machines EHB 16/2.4 S R/L is equipped with an
electronic switch allowing the slow start of drilling.
With this switch the speed can be regulated according to the pressure on
the button.
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Additional the machine has a change-over switch in the switch handle for
reverse action.
Use the change-over switch only when the spindle is stopped!
Speed Selection
The machine is equipped with a mechanical two-speed gearbox. Select the
required speed by pressing-in, shifting and engaging. The position of the
lower speed is in direction of the working spindle. Change the speed only
when the machine is not running, and support the speed-changing by
slightly rotating the work spindle.
15
Advertisement
