Safety Cut-Out; Cleaning And Maintenance - Kalorik JK 42656 Manual

Fax +1 305 430 9692
The kettle will not re-boil until the kettle is not switched on again.
•
To keep the water warm: this convenient function keeps the water
•
near boiling temperature at all times. To select this function, keep
the "Boil/Off/Keep Warm" button (b) pressed for more than one
second. The light ring (8) is blinking red, indicating the kettle is on
and the keep warm function is activated. When the water boils the
kettle will beep and shut-off temporarily, and when the water
temperature will have dropped down to a certain level, the kettle
will start boiling the water again to keep it warm at all times.
ATTENTION: to use the keep warm function, always make sure the
water level is above the "MIN" level line to make sure that the kettle
will properly shut off after the water has reached boiling point.
To stop the keep warm feature, simply switch the kettle off, select a
•
new temperature, or lift the kettle from its power base.
The kettle may be stored on the power base when not in use.
•
Always disconnect the power supply when not in use.
•
When pouring a large quantity of hot water, pour slowly and do
•
not incline the kettle past the horizontal line to avoid burns and
injuries.

SAFETY CUT-OUT

This cordless water kettle is protected with an automatic safety
•
device, if accidentally switched on without water in the kettle.
If this happens, switch off the appliance by putting the switch in
•
the OFF position and wait about 10 minutes for the element to
cool. Then pour in sufficient cold water to cover the element. This
will reset the safety device.
The kettle may then be used as normal.
•

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the
•
appliance is unplugged from the supply socket and fully cooled
down.
To clean the exterior surfaces, simply wipe over with a soft, damp
•
cloth and dry thoroughly.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
7
Assembly page 7/32
special instruction from Team
Print only
JK 42656 - 120501