Operation; Safety Cut-Out - Kalorik JK 31099 Manual

Fax +32 2 359 95 50

OPERATION

Always remove the jug from the power base before filling it or
•
before any operation.
Open the lid and fill the tank with fresh water, paying attention
•
not to fill under the minimum mark and above the maximum
mark on the water level indicator. Too little water may result in the
kettle switching off before the water has boiled.
Close the lid. Make sure it closes correctly.
•
Make sure the spout filter and lid is well in position, as else the
•
auto-shut off feature would not work.
Put the jug onto the power base, plug into the wall socket and
•
switch on by pressing down the switch located under the handle.
The blue pilot light comes on indicating the appliance is operating.
The jug kettle will switch off automatically when the water has
•
boiled. However, you can stop the jug kettle anytime by putting
the switch in off position.
For instant reboiling, wait until water has cooled down and switch
•
on the appliance again.
NOTES:
• Ensure that the switch is free of obstructions and the lid is firmly
closed, the kettle will not turn off if the switch is constrained or if
the lid is opened.
• The kettle will not re-boil until the switch is pressed again. The
kettle may be stored on the power base when not in use.
• Always disconnect the power supply when not in use.
• When pouring a large quantity of hot water, pour slowly and do
not incline the kettle past the horizontal line to avoid burns and
injuries

SAFETY CUT-OUT

This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
5
Assembly page 5/24
special instruction from
USK JK 31099 - 100510
Team