Safety Cut-Out - Kalorik JK 40770 Instruction Manual

• For instant re-boiling, wait until water has cooled down and switch
on the appliance again.
• The kettle will not re-boil until the kettle is not switched on again.
• To keep the water warm: this convenient function keeps the water
always near boiling temperature. To select this function, keep the
"Boil/Off/Keep Warm" button (b) pressed for more than one second.
The water gauge (8) is blinking red, indicating the kettle is on and the
keep warm function is activated. When the water boils, the kettle will
beep and shut-off temporarily, and when the water temperature will
have dropped down to a certain level, the kettle will start boiling the
water again to keep it warm.
ATTENTION: to use the keep warm function, always make sure the water
level is above the "MIN" level line to make sure that the kettle will
properly shut off after the water has reached boiling point.
• To stop the keep warm feature, simply switch the kettle off, select a
new temperature, or lift the kettle from its power base.
• The kettle may be stored on the power base when not in use.
• Always disconnect the power supply when not in use.
• When pouring a large quantity of hot water, pour slowly and do not
incline the kettle past the horizontal line to avoid burns and injuries.

SAFETY CUT-OUT

This cordless water kettle is protected with an automatic safety
•
device, if accidentally switched on without water in the kettle.
If this happens, switch off the appliance by putting the switch in the
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will
reset the safety device.
The kettle may then be used as normal.
•
www.KALORIK.com
8
JK 40770 - 170120