Table of Contents
Advertisement
4.2 Daily maintenance
Make each operator aware of (and responsible for) the following daily maintenance requirements:
Remove dust, moisture, and other contaminants with a clean, soft brush or soft, lint-free cloth. Do not
use objects that could damage the tool.
Make sure that all external pins and screws are in place.
When the tool is not in use, remove the battery pack and store the tool in the carrying case. Do not
store the battery pack in the charger.
4.3 Periodic visual inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the tool or be supplied to personnel responsible for the tool. Base your inspection frequency
on the amount of use, working conditions, operator training and skill, and established company standards.
1. Remove all excess lubrication from the crimping area of the tool.
2. Check dies for damage or excessive wear.
3. Inspect the crimping area for metal particles. The presence of metal particles indicates a lack of
lubrication or misaligned or worn parts.
4. If damage or abnormal wear is evident, return the tool to TE for repair. Refer to section 6,
Replacement and repair).
Rev E
409-10104
15 of 18
Advertisement
Table of Contents
