Advertisement
Note: The gutter profile is only inserted or clipped in from the side after the glazing has been
completed. Otherwise, the insertion of the glazing would not be possible. If the structural
situation does not allow the glazing to be inserted this way, the panes can of course also be
mounted sideways, which is much more cumbersome. - Please ask us in advance for the
procedure in such cases!! - In these cases, a so-called Repair-roof strut - with a cover shell
may be necessary.
Practically, 6 hands are needed: 4 hands to slide the panes - weight approx. 32 kg - from in
front of the sidewalls into the roof bars and 2 hands inside the greenhouse to guide the pane
into the ridge profile at the top! Make sure that the silicone plug-in gasket remains in the
intended position! Otherwise, the process must be repeated.
Attention! These silicone gaskets must be put on before inserting the glazing!! Later
insertion is not possible without disassembly of the panes!!!!
If the gap between the bars is too narrow, please move the bar to the required position!
The exact position of the bars can be corrected later by positioning the strut connections in the
eaves area!
During the pane assembly, the "glass brakes" (a manifold tilted sheet metal piece) are inserted
into the eaves profile. The panes must be pushed up into the ridge so far that this sheet can be
inserted into the intended eaves profile slot. This ensures a secure fit of the roof panes.
After complete assembly and pressing in of the sealing profiles, the beginning/end of the glass
should be sealed with silicone to ensure that the edge of the ISO safety glass panes does not sit
in water.
Since all seals are pressed in from the inside, the final position of the glazing is only reached
then. - Due to the seals, the glazing is shifted upwards by approx. 2 mm.
{picture}
11.Assembly of the gutter profile and the downpipes
{picture}
-
12. Assembly of the corner and end caps - Form and edge sheets.
{picture}
Note: Please inject silicone into the profile contours of the plastic end caps to create a seal both
in the gutters and to the ridge.
13.Final work - pushing in the seals.
Advertisement
