Wind The Bobbin; Removing Bobbin Case From Shuttle - Singer C5650 Instruction Manual

Wind the Bobbin

A
B
1. Place the thread spool on the spool pin. Slide a spool cap
firmly against the spool.
2. Place the thread around the thread guide (A) from back to
front and around the bobbin winding tension disc (B), mak-
ing sure that the thread is pulled snuggly between the discs.
3. Thread through the hole in the bobbin (C) from the inside to
the outside.
4. Place the bobbin on the bobbin winding spindle. Make sure
the bobbin is pushed down firmly.
5. Push the bobbin winding spindle to the right. Hold the
thread end, and press the foot control to start winding.
Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to
the sewing position (left) before sewing.

Removing Bobbin Case from Shuttle

1. Raise the needle to its highest position by rotating the hand
wheel toward you (counter-clockwise).
2. Remove the extension table / accessory box. Open the
bobbin access cover by pulling it down. With your fingers,
pull open the bobbin case latch as shown, and take out the
bobbin case from the shuttle.
3. Release the latch, and bobbin will drop out of the case.
10 – P reparations 10 – P reparations
English English
After a few turns, take your foot off the foot control to
stop winding. Cut the excess thread tail above the bobbin,
making sure to trim it close to the bobbin. Step on the foot
control to resume winding. When the bobbin is full, the
bobbin winding will slow down and stop automatically.
Note: You can also start the winding by long pressing the
start/stop button.
6. Push the bobbin winding spindle to the left. Remove the
bobbin and cut the thread.
C