removing bobbin case, face plate
and buib
DANGER:
bobbin case, face piate and iight buib
disconnect power-iine puig from eiectri-
cal supply.
REMOVING AND
BOBBIN CASE
• Raise the presser foot.
• Turn hand wheel toward you until
needle is above the presser foot.
• Remove needle plate as instructed on
pa§dl.
® Remove bobbin.
bobbin
To remove
holder to back as far as it will go. Lift out
bobbin case.
bobbin
To replace
end under the
feed
bobbin case
under
illustrated.
Turn holder all the way forward
to lock
bobbin case in position. After
locking
bobbin case in position, check
that
bobbin case
slight rotational movement.
® Replace
needle plate.
• Fully close slide plate.
FACE PLATE
REMOVING
• Loosen and remove screw and remove
face plate by sliding it downward.
REPLACMG FACE PLATE
® Slide face plate
gaged under edge cf top
® Align screw hole at lower
with screw hole
and tighten screw.
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
Before
removing
REPLACING
turn bobbin
case,
guide the forked
case,
and then
draw
the
position plate as
is
not jammed, but has
up
is en
so that rim
cover.
edge of plate
in machine and replace
maszynykrawieckie.shophurt.pl
case
the
45