Sim Card Installation - Honeywell Dolphin 7600II User Manual

SIM Card Installation

Short for Subscriber Information Module, a SIM card stores the subscriber's personal information, GSM/
GPRS radio settings, security keys, contacts, etc. SIM cards can be installed in multiple devices, which
enables you to switch devices without losing personal and setup information.
SIM Card Requirements
Before installing the SIM card:
• The SIM card must be activated by the service provider.
• The terminal must be powered down (suspend mode).
Note: If no SIM card is installed, you can still make emergency phone calls such as 9-1-1, for example.
To Install a SIM Card
On the Dolphin terminal, the SIM card slot is located under the SIM card door under the battery well, which
enables easy access to the SIM card while securing it under an installed battery.
You must use a Torx 5 (T5 x 50) screwdriver to open the SIM card door.
1. Tap Blue + Backlight to put the terminal in Suspend mode.
2. Lay the terminal keyboard facing down.
3. Remove the main battery.
4. Using a Torx 5 screwdriver, unscrew the SIM card door and set it aside.
5. Slide the metal door down towards the I/O connector to unlock it. (Refer to the arrows on the metal
door.) Lift the metal door.
6. Place the SIM card in the base of the connector with the contacts facing down.
SIM Card Door
Metal Door
7. Fold the metal door down and slide the door up to lock the SIM card in place. You will hear a click
when the door is locked.
Note: You will not be able to close the SIM card door unless the SIM card is locked in place.
8 - 2
Guiding Arrows
Rev (a) 01
5/29/08
SIM Card
SIM Card Interface
Dolphin® 7600II Mobile Computer User's
Guide–Preliminary