Suspend Mode - Honeywell Dolphin 7600II User Manual

Suspend Mode

Suspend mode suspends terminal operation. The terminal appears to be "off" when in suspend mode.
The terminal is programmed to go into suspend mode automatically when inactive for a specified period
of time. You can set this time period in the Power setting.
To Put the Terminal in Suspend Mode
Press the Blue + Backlight keys.
Note: You should always put the terminal in suspend mode when you change the battery pack; see Changing the
Main Battery Pack on page 3-21.
To Resume Terminal Operation
To resume terminal operation (or "wake" the terminal from suspend mode),
• Press the Blue + Backlight keys.
OR
• Press the Scan key .
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Scan key, the main battery might be too low to resume
operation. To check, remove the battery and install a fully charged battery or connect the terminal to a
Dolphin charging peripheral.
Care and Cleaning of the Dolphin Terminal
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
3 - 26 Rev (a) 01 Dolphin® 7600II Mobile Computer User's
5/29/08
Guide–Preliminary