Remove Programs - Honeywell Dolphin 7600II User Manual

Remove Programs

Remove Programs enables you to remove programs installed on the terminal. Use this setting to
troubleshoot when you receive messages that the terminal is out of memory. The programs removed are
removed from RAM memory. Any program (usually CAB or DLL files) stored in the Autoinstall folder (My
Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the Autoinstall process, see
For information about the hard reset process, see
1. Tap Remove Programs. In the list, select the program you want to remove.
2. Tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
4. Verify that the program no longer appears in the list.
Dolphin® 7600II Mobile Computer User's
Guide–Preliminary
Let Autoinstall Run
Hard Reset (Cold Boot)
Rev (a) 01
5/29/08
on page 2-7.
on page 2-11.
6 - 13