Control Commands; Stop:sensorstop; Start:sensorstart - DFRobot SEN0521 User Manual

5.8g microwave radar module
Table of Contents

Advertisement

Enable active output of
target detection results
with a frequency of 5
seconds, and immediate
output of data when there
is a change.
Disable active output of
target detection results.
The module will only output
data when a "getOutput"
command is issued to query
it.
4.2

Control Commands.

Stop:sensorStop

4.2.1
Describe:
Stop the module from running while it is in the running state.
Note: Before configuring parameters, it is necessary to send a stop command to stop the module and enter the parameter
configuration mode.
Command:
sensorStop
Parameter item:
Empty.
Response:
Done
Error
Example:
Stop Module.

Start:sensorStart

4.2.2
Describe:
setUartOutput 1 1 1 5
leapMMW:/>
setUartOutput 1 1 0 1600
leapMMW:/>
No parameters.
Command executed successfully.
Command execution failed. The module is not in running state.
sensorStop
leapMMW:/>
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SEN0521 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents