Linhai HY510S Service Manual page 68

CHAPTER 3 ENGINE
Install oil dip rod, start the engine and allow it to run
for several minutes at idling speed.
Turn off the engine and wait for about 3 minutes,
and then check the oil level on the dipstick.
Caution:
The engine oil should be changed when the engine is
warm. If the oil filter should be replaced, replace engine
oil at the same time.
Replacing Oil Filter
Remove relative parts ( see Replacing Engine Oil)
Remove oil filter① with the special tool
Install washer and drain bolt
Install new oil filter with the special tool
Fill engine oil (about 2000ml) and check (see
Replacing Engine Oil)
Tool: Oil Filter Wrench
Engine Oil Capacity
When replacing oil: 1.9L
When replacing oil filer: 2.0 L
Engine overhaul:2.2 L
LH500ATV-D SERVICE MANUAL14.0
CHAPTER 3 ENGINE PAGE. 3- 37