Linhai HY510S Service Manual page 182

CHAPTER 5 FINAL DRIVE
16. Install the large boot bands onto each
boot.
CAUTION
It is critical to avoid undue stress on the
rubber boots after the drive axle is
installed and the vehicle is run. Don't
twist the boot, and always set the both
ends in designed position.
17. Secure all large boot bands. Bend down
the tab on the boot band and secure the
tab with the locking clip and tap them with
a plastic hammer. Make sure they are
locked in place.
18. If removed, install the stopper ring and
make sure it is seated correctly in the
drive axle groove.
19. Apply molybdenum disulfide grease to the
end splines.
5.9 REAR HUB INSPECTION
1. Remove rear wheel.
2. Remove the cotter pin on the rear wheel driving shaft nut, than remove the nut.
3. Remove the rear disc brake caliper.
LH500ATV-D SERVICE MANUAL 14.0
CHAPTER 5 FINAL DRIVE. 5- 12