Linhai HY510S Service Manual page 37

CHAPTER 3 ENGINE
3.1.2 Engine Installation
Put engine onto the frame，install the two lower mounting bolts and nuts.
Then install the upper and lower engine hangers.
Engine upper hanger bolt:35～45N.m
Tightening torque:
Install:
--Water outlet and inlet hoses to engine with proper clamps.
--Positive and negative starting wires to engine.
--Connect all the connectors.
--Spark plug cap.
--Gearshift rod to engine.
--Air filter, carburetor and removed parts.
3.1.3 Removal and Installation of Front and Rear Axle
Support the vehicle with jack, make sure the vehicle will not fall.
Remove:
--Plastic parts for frame(→Chapter 2)
--Front and rear wheels and arms(→Chapter 6)
--Air filter(→engine service chapter)
--Carburetor(→engine service chapter)
--Engine
--Rear brake caliper(→7-4)
1. Nut 2. Bolt 1
7. Clamp 8. Breather Hose, Front Axle
11. Breather Hose, Rear Axle
12. Rear Brake Disk
Engine lower hanger bolt:50～60N.m
3. Bolt 2 4. Front Axle
13. Bolt 5 14. Rear Drive Shaft
5. Bolt 3 6. Front Drive Shaft
9. Bolt 4 10. Rear Axle
LH500ATV-D SERVICE MANUAL14.0
CHAPTER 3 ENGINE PAGE. 3- 6