Specifications - United States Stove King Manual

Heating Specifications
Fuel Burn Rate*
Burn Time (lowest setting)
Hopper Capacity
* Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%.
Use PFI listed fuel for best results.
Dimensions
Height 34" (864mm)
Width 26" (660mm)
Depth 27" (686mm)
Weight 210 lbs (95.5kg)
Electrical Specifications
Electrical Rating 110-120 volts, 60 HZ, 3.0 Amps
Watts (operational) 175 (approx.)
Watts (igniter running) 425 (approx.)
VISIBLE SMOKE
The amount of visible smoke being produced can be an effective method of determining how efficiently the
combustion process is taking place at the given settings. Visible smoke consist of unburned fuel and moisture
leaving your stove. Learn to adjust the air settings of your specific unit to produce the smallest amount of visible
smoke. Wood that has not been seasoned properly and has a high wood moisture content will produce excess
visible smoke and burn poorly.
FUEL CONSIDERATIONS
Your pellet stove is designed to burn premium hardwood pellets that comply with the Pellet Fuels Institute(PFI)
standards (minimum of 40 lbs density per cubic ft, 1/4" to 5/16" diameter, length no greater than 1.5", not less
than 8,200 BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million).
Pellets that are soft, contain excessive amounts of loose sawdust, have been, or are wet, will result in reduced
performance. Store your pellets in a dry place. DO NOT store the fuel within the installation clearances of the
unit or within the space required for refueling and ash removal. Doing so could result in a house fire. DO NOT
USE CHEMICALS OR FLUIDS TO START FIRE. HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE
AWAY. CONTACT MAY CAUSE SKIN BURNS.
SAFETY AND EPA COMPLIANCE
Your pellet stove has been safety tested and listed to ASTM E1509-12 (201&), ULC-S627-00 and (UM) 84-HUD.
This manual describes the installation and operation of the King/Ashley model 5500, 5500M pellet stove. This heater
meets the 2020 U.S. Environmental Protection Agency's crib wood emission limits for wood-heaters sold after May
15, 2020. Under specific EPA test conditions burning wood pellet fuel this heater has been shown to deliver heat at
a rate of 8,932 to 25,701 Btu/hr. This heater achieved a particulate emissions rate of 1.3 g/hr when tested to method
ASTM E 2779 / EPA Method 28R and 64% efficiency.
WARNING: It is against federal regulations to operate this wood heater in a manner inconsistent with the
Note: Register your product on line at www.usstove.com. Save your receipt with your records for any claims.

Specifications

2.0 - 6.0 lbs./hr (0.9 - 2.7 kg/hr)
60 hrs
120lbs (55kg)
operating instructions in the owner's manual.
3