Vox Intercom (Default: Disable); Vox Sensitivity (Default: 3); Hd Voice (Default: Enable) - Sena OUTSTAR S Manual

10 COnFIgURATIOn SETTIng

10.2.6 VOX Intercom (Default: Disable)

If this feature is enabled, you can initiate an intercom conversation
with the last connected intercom friend by voice. When you want
to start intercom, say a word such as "Hello" loudly or blow air into
the microphone. If you start an intercom conversation by voice, the
intercom terminates automatically when you and your intercom friend
remain silent for 20 seconds. However, if you manually start an intercom
conversation by tapping the Center Button, you have to terminate the
intercom conversation manually. However, if you start the intercom by
voice and end it manually by tapping the Center Button, you will not be
able to start intercom by voice temporarily. In this case, you have to tap
the Center Button to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind noise. After
rebooting the Bluetooth system, you can start intercom by voice again.

10.2.7 VOX Sensitivity (Default: 3)

VOX sensitivity can be adjusted depending on your riding
environment. Level 5 is the highest sensitivity setting and level 1 is the
lowest.

10.2.8 HD Voice (Default: Enable)

HD Voice allows you to communicate in high-definition during phone
calls. This feature increases the quality so that the audio will be crisp
and clear during phone call conversations. If this feature is enabled,
incoming phone calls will interrupt intercom conversations and audio
from the SR10 will not be heard during intercom conversations. Three-
Way Conference Phone Call with Intercom Participant will not be
available if HD Voice is enabled.
Note:
• Refer to the manufacturer of your Bluetooth device that will be
connected to the Bluetooth system to see if it supports HD Voice.
• HD Voice is active only when Audio Multitasking is disabled.
OUTSTAR S Bluetooth
®
Helmet | 40