Advertisement
www.aeroplusrc.com
Sand the area on the horn that fits inside the rudder so the glue bonds better
Glue the rudder hinges into both the rudder and fin using epoxy glue. Remember to use vaseline on the hinge joint. While drying use tape to keep it
in alignment.
Glue the rudder horns through the rudder with epoxy, wipe off excess glue while it is wet. Use the ball joint and bolt while gluing to maintain
alignment. While still movable measure that the same amount pushes out each side. Care needs to be taken here otherwise your rudder geometry
will be incorrect.
Assemble the rudder servo control arm as below, drill holes for screws and use cyno to stop the nuts from coming loose.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
