Advertisement
www.aeroplusrc.com
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue, use a bolt through the horns when gluing to make sure the alignment is correct.
Fit the aileron servo and drill fine holes where the servo screws will fit. Then apply thin cyano to strengthen the holes.
#(Sbach 20CC used single horn)
If required install a servo extension lead onto the servo, remember to use a servo plug clip.
Fit the servo and centre the servo arm.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
