Table of Contents
Advertisement
Notes
The blower and piping protrude beyond the rim.
Install this product according to the installation guide.
Fixture dimensions are nominal and conform to
tolerances in GB/T 1804-1992V.
Floor support under bath must provide for a minimum
of 816.5 kg.
If installing a rim mount faucet, make sure there is no
interference with drain overflow and circulating system
before drilling any holes. Consult local and national
codes for minimum air gap requirements if installing a
spout on the faucet deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
A blower motor/control access panel is required.
INSTALLATION
1. Prepare the Site - Wood Construction
CAUTION: Risk of product damage.
support the bath with airjets by the rim.
NOTICE:
Adequate floor support must be provided.
Consult the roughing-in sheet packed with your bath
for specific floor loading requirements.
NOTICE:
Provide adequate ventilation and a minimum
of 15 cubic feet (.4 cubic meters) in the installed
location for cooling the motor and to supply sufficient
air for the blower. Do not install the blower motor
closer than 1 (2.5 cm) from the wall or other objects.
''
NOTE:
This bath may be installed in a drop-in or an
island installation. An island installation requires a
four side surround.
NOTE: Please use the shutter-like access panel.
1070462-T01-B
1.
Do not
1''(2.5cm)
-6-
GB/T 1804-1992V
816.5 kg
70%
/
-
15
0.4
Advertisement
Table of Contents
