Operating Sequence - Kohler K-1457T-G Installation Instructions Manual

11. Confirm Proper Operation (cont.)
·
User Keypad leep Modes - To enhance your ''
bathing experience, the keypad is programmed to
darken after approximately 15 seconds of inactivity.
Only the last feature selected will remain illuminated.
To resume normal operation, press any key or turn
the outer ring. Approximately 60 seconds after all
equipment is turned off, the keypad will darken
completely to conserve power. Press the power
button or turn the outer ring to reactivate the keypad.
Activates Mode Selected
Rotate Outer Ring to Access Desired Mode
Chromatherapy Specific Color (if provided)

12. Operating Sequence

For All Installations
Preliminary Checks
·
Temporarily remove all access panels.
·
Ensure that the area around the blower motor is free
of sawdust, insulation, dirt, or other small loose
debris. Such material could clog the blower motor s
air ducts and reduce the air flow through the blower
motor.
·
Make sure the union connection at the check valve
is securely hand tightened.
·
Check that the piping from the blower motor and the
check valve to the butterfly valves is properly
connected and supported.
·
Ensure that cable ties or other clips support the air
piping and electrical harnesses at the bath.
·
Ensure that any unused electrical connectors are
supported above the floor.
·
Turn on power to the unit.
NOTE: Troubleshoot any problems as per the
'' Troubleshooting section. ''
Confirm Blower Motor Operation
·
Fill the bath to a level at least 2 (5 cm) above the
top of the highest airjet.
·
Press the power button on the user keypad.
·
Observe that the user keypad icons illuminate. The
air flow mode icon and the chromatherapy cycle
icon (if provided) are lighted green. The Zone 1,
Zone 2, and Zone 3 icons are also illuminated green
since all three zones are activated.
·
Observe that the blower motor starts at a midrange
speed.
1070462-T01-B
''
Zone 1
1
Air Flow Mode
Power On/Off
/
''
11.
·
Rotating Ring Key Pad
12.
·
·
'
·
·
·
·
·
·
)
·
·
·
-15-
( )
15
60
Zone 2
2
Zone 3
3
Surge Mode
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Chromatheray Cycle (if provided)
Purge Mode
1 2 3
2''(5.1