Table of Contents
Advertisement
8. Complete the Finished Deck
For Drop-Installations
·
If you have not already done so, carefully remove
the protective tape from the bath rim.
·
Cover the framing with water-resistant deck material.
Seal the joints between the bath rim edge and the
water-resistant deck material with silicone sealant.
·
Install the faucet trim according to the instructions
packed with the trim.
9. Complete the Concrete Installation
For Island Installations
·
If you have not already done so, carefully remove
the protective tape from the bath rim.
·
Apply mortar and tile to any wall, deck, and
surround material as needed.
·
Apply a bead of sealant where the tile meets the
bath surface.
·
Install the faucet trim according to the instructions
packed with the trim.
10. Clean-Up After Installation
For All Installations
·
Clean the area around the blower motor of all dust
and debris.
·
Use warm water and a liquid detergent to clean the
surface of the bath.
as they may scratch and dull the bath surface.
not use powdered cleaners unless the cleaner is
fully dissolved in water
block the airjets.
Do not use bleach or ammonia
cleaning solutions
solutions can damage the bath surface. Refer to the
homeowners guide for normal cleaning
recommendations.
1070462-T01-B
Do not use abrasive cleansers
. Solid substances could
. Chemically active cleaning
Finished Deck Material
8.
·
·
·
9.
·
·
·
·
10.
·
·
,
Do
Apply silicone sealant to the edges of the water-resistant
deck material and the finished deck.
Water-Resistant Deck Material
Framing
Bath
-13-
Advertisement
Table of Contents
