Advertisement
install Sanding Disc and Disc Guard
1. Wipe down the Backing Disc with
denatured alcohol to remove any
residue and ensure a secure bond.
2. Remove backing from
Sanding Disc (32).
3. Align perimeter of Sanding Disc over
the Backing Disc and press Sanding
Disc firmly onto the Backing Disc.
4. Position Disc Guard (33) against
Disc/Pulley Housing, aligning holes
in Guard with mounting holes in
Housing. Fasten securely using
six Self-Tapping Screws (55).
Mounting Work table
1. Insert the round end of the Table Support
Bar (56) into the mounting hole on the side
of the Base (66) as shown.
2. Turn the Support Bar so the flat side
of the Bar is facing the Set Screws.
3. Tighten the two M8 x 2 0 m m Set
Screws (65) on the side of the
Base to secure the Bar.
4. Slide the Work Table assembly
onto the Table Support Bar.
5. Adjust the Table so the edge is a
maximum of 1/16 inch from the
Sanding Disc.
6. Tighten the two M8 x 10 m m
Set Screws (50) on the
Table Support (51) to
secure the Work Table.
Item 59220
Disc /
pulley
Housing
M8 x 2 0
M8 x 2 0
Set
Set
Screw
Screw
M8 x 10
Set
Screw
For technical questions, please call 1-888-866-5797.
Sanding
Disc
Backing
Disc
Disc
Guard
table Support
Bar
table
Support
Screw
Work
table
Page 11
Advertisement
