Table of Contents
Advertisement
10.16
Handlebar position
10.17
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
–
Mount protection cap
The holes on the handlebar supports are placed at a distance
A
of
from the center.
Hole distance A
The handlebar can be mounted in 2 different positions. In this
way, the handlebar can be mounted in the most comfortable posi-
tion for the rider.
H01188-10
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
H01189-10
Screw, handle-
bar support
–
Position the handlebar.
TUNING THE CHASSIS 10
1
.
3.5 mm (0.138 in)
1
. Remove the handlebar clamp. Remove the
2
. Take off handlebar supports
4
and push through nuts
2
.
M10
40 Nm (29.5 lbf ft)
3
.
5
from
Loctite
243™
®
49
Advertisement
Table of Contents
