Performance Indicator - Kohler K-80021T-KPC40-01R Installation Manual

Kitchen water filtration system carafe series
Table of Contents

Advertisement

PERFORMANCE INDICATOR

PRODUCE: When first time Start-up procedure is finished,
each time open the water filtration faucet to get the pure
water in&out water TDS value will light on shut off the
faucet, all lights black out
When filter life is running low or out each time open the
filtration faucet filter LEDs will change to orange with
normally lighting on or blinking.
Washout
Expiration notice
1276024-T01-G
TDS In
TDS
TDS Out
TDS
The first stage filter
pertormance indicator
The second stage filter
performance indicator
The third stage filter
performance indicator
!
Washout
!
When the first stage filter is
brand new/replaced or the
system after every 24 hours
working, the system will do
washout to get it ready for
making clean water.
!
If power cut during the
washout, it will continue
washout until time over when
plug the power again.
!
!
/
24
5
15
,
!
!
Filter Status: Filter life is
running low/ less than 10%
!
Filter LEDs will change to
orange with 3 short beep as
the filtration faucet is ON
when its life is running low/
less than 10% left. (Users
need to replace filters and
reset the indicator, and then
the LED turns white right after
the reset.)
!
10%
!
10%
TDS
(
)
Plug in
Normal
Expiration notice
-10-
LED
!
Plug IC Self-test Status:
!
Diagnosis Succeeded When
the user plug power into the
device, the IC self-test will be
automatically conducted. When
it is processing the self-test, the
LED displays looped "single
dash" with one short beep.
!
IC
!
IC
,
!
Status: Produce well
!
When produce the pure water
with performance well filters,
the filter indicator will be white
&the TDS value be displayed.
!
!
/
,
TDS
!
Filter Status: Immediate
change needed
!
Orange LED starts blinking
when the filter run out and
needs to be change
immediately when users turn
the filtration faucet ON, it
comes with 0.2 sec repeating
short beeps. (Users need to
replace filters and reset the
indicator, and then the LED
turns white right after the reset.)
Note:
TDS reduction problem
will blink orange LED with 3
short beep.
!
/
!
,
0.2
0.2
RO

Advertisement

Table of Contents
loading

Table of Contents