Table of Contents
Advertisement
OPERATION
Right control lever (2)
Direction of operation
Right control lever (2)
REMARK
Use this lever to temporarily raise or lower the speed set
by the e ngine s p eed contro l sw itch de scribed on
"SWITCHES(3-10 page)".
9.1.2 OPERATION METHOD FOR BLADE, DUAL TILT, AND PITCH USING
RADIO CONTROL
Switching between dual and single mode
1.
Set the blade/ripper selector switch to the blade position.
2.
Keep the blade FLOAT switch pressed, operate the lever
fully to the left or right, and hold in position for approx. 2
seconds.
3.
Each time the above operation in Step 2 is carried out,
the mode is switched between dual mode and single
mode.
4.
When right control lever (1) is operated, the blade is tilted
(dual tilt or single tilt).
Left tilt: Operate lever to left
Right tilt: Operate lever to right
REMARK
When operating by radio control, it is possible to
switch the mode regardless of the position of the dual
tilt/single tilt selector switch on the blade lever.
The mode when the control method is switched from
on-board → radio control depends on the position of
the dual tilt/single tilt selector switch on the blade
lever.
The mode when the control method is switched from
radio control → on-board depends on the position of
the dual tilt/single tilt selector switch on the blade
lever.
Front / rear direction
Push
Pull
Deceleration
Acceleration
9. EXPLANATION OF COMPONENTS
3-7
Advertisement
Table of Contents
