Table of Contents
Advertisement
9. EXPLANATION OF COMPONENTS
9.1.1 CONTROL LEVERS
Proportional control is used for operation of the control levers, so it is possible to control the speed according to
the amount the levers are operated. In addition, any combination of levers can be used at the same time.
Right control lever (1)
Direction of operation
Right control lever (1)
:Keep the push button pressed and operate fully to the
blade LOWER position.
2 :For details of the method of operating the pin-puller,
"OPERATION METHOD FOR PIN-PULLER USING RADIO
CONTROL(3-8 page)".
REMARK
Use the toggle switch on "SWITCHES(3-10 page)" to
switch between the blade and ripper.
When in the FLOAT condition, press the push button
switch to cancel the FLOAT.
If the blade lever is operated to the RAISE position
from FLOAT, the FLOAT is canceled.
Left control lever (1)
Direction of
operation
Left control lever (1)
When the push button is pressed, the brakes are
applied, regardless of the position of the control
levers.
When the travel direction is set to neutral, the brakes
are applied.
3-6
Front / rear direction
Blade or ripper operation
Push
Pull
Blade LOWER
Blade RAISE /
/ ripper DOWN
ripper UP
Front / rear direction
Travel operation
Push
Pull
Forward
Reverse
Left / right direction
Blade or ripper operation
Left
Left tilt / ripper
Right tilt / ripper
tilt in
Left / right direction
Steering operation
Left
Right
Left turn
Right turn
OPERATION
Push button
Blade or ripper
operation
Right
Blade FLOAT/pin-
tilt back
puller pull out
Push button
Brake operation
ON (push)
Brake
2
Advertisement
Table of Contents
