Table of Contents
Advertisement
Roughing-In
2" (5.1 cm) Min Drain Hole Clearance through Wall for AFD Version
Espace min d'orifice du drain de 2" (5,1 cm) travers le mur pour la version AFD
2" (5,1 cm) de espacio mnimo para el orificio del desage a travs de la pared para la versin
del desage arriba del nivel del piso
Drain Cutout
Découpe du drain
Abertura del desage
14"
(35.6 cm)
14-1/4"
8"
(36.2 cm)
(20.3 cm)
6"
(15.2 cm)
4" (10.2 cm)
3-1/2" (8.9 cm)
8-3/4"
2" (5.1 cm) D.
(22.2 cm)
Drain/Drain/Desage
60" (152.4 cm)
Recommended Support Clip Location (5 total)
Emplacement recommandé pour les clips de support (5 total)
Ubicación recomendada para los clips de soporte (5 total)
NOTICE: All dimensions are nominal. The stud opening tolerance is +1/8" (3
mm)/-0. Carefully measure your fixture before determining enclosure size. Some
shimming between the stud frame and the fixture may be required. If a firewall is
required, rough-in dimensions will have to increase according to the thickness of the
firewall material. Stud opening dimensions must be measured toward the exposed
side of the wall material. Dimensions given in the rough-in information are crucial for
proper installation. Construct the framing and plumbing accurately.
Position the bath for drainage clearance through the floor joists or slab, and for
convenient plumbing installation.
Position studs as shown for installing attachment clips and plumbing fixtures.
Install an access panel at the drain end of the bath. The access panel is not shown.
If installing this bath with a shower door, refer to the shower door manufacturer's
instructions for any special framing considerations.
Plan de raccordement
NOTICE: Toutes les dimensions sont nominales. La tolérance de l'ouverture du
montant est de +1/8" (3 mm)/-0. Mesurer soigneusement votre appareil avant d'en
déterminer la taille de son logement. Un calage entre le cadre du montant et
l'appareil sanitaire pourrait être nécessaire. Si un pare-feu est requis, les dimensions
de raccordement devront augmenter en fonction de l'épaisseur du matériau du
pare-feu. Les dimensions d'ouverture des montants doivent être mesurées vers le côté
1064911-2-C
60" (152.4 cm)
14"
(35.6 cm)
30" (76.2 cm)
8"
(20.3 cm)
8-3/4" (22.2 cm)
31-1/2" (80 cm)
22-1/4"
(56.5 cm)
2-3/4"
(7 cm)
71090112
71090122
3" (7.6 cm)
6
31-1/2"
(80 cm)
71090110
71090120
76-3/4"
(194.9 cm)
71090112
71090122
79"
(200.7 cm)
Sterling
Advertisement
Table of Contents
