Table of Contents
Advertisement
Installation
STEP 2 Leveling your washer
B
14 English
WA8700K(TSE)_DC68-03823P-00_EN.indd 14
A
C
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
3. If the washer is level, the pulsator (A) is
positioned at the center of the water as
shown in the figure.
4. If the washer is not level, level your
washer by turning the leveling feet
clockwise or counterclockwise as
necessary.
NOTE
Turn the leveling feet clockwise (B) to lower
the washer, and counterclockwise (C) to
raise the washer.
8/18/2020 8:13:34 PM
Advertisement
Table of Contents
