HIKOKI CS 3625DC Handling Instructions Manual

HIKOKI CS 3625DC Handling Instructions Manual

Advertisement

Quick Links

CS 3625DC ∙ CS 3630DC
CS3630DC
Handling instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CS 3625DC and is the answer not in the manual?

Questions and answers

Summary of Contents for HIKOKI CS 3625DC

  • Page 1 CS 3625DC ∙ CS 3630DC CS3630DC Handling instructions...
  • Page 3 0.5– 1 mm...
  • Page 5 3...
  • Page 7: General Power Tool Safety Warnings

    SYMBOLS WARNING This chain (CS3625DC CS3630DC) designed especially for tree care and surgery. Only WARNING The following show symbols used for the machine. persons trained in tree care and surgery may use this saw. Observe all literature, procedures and Be sure that you understand their meaning before recommendations from the relevant professional use.
  • Page 8 3) Personal safety f) Keep cutting tools sharp and clean. a) Stay alert, watch what you are doing and use Properly maintained cutting tools with sharp cutting common sense when operating a power tool. edges are less likely to bind and are easier to Do not use a power tool while you are tired control.
  • Page 9 If the unit does not working properly, immediately stop using and request repair from your HiKOKI Authorized Service Center.
  • Page 10 If installed incorrectly, the saw chain will come off the with the applicable safety standards. guide bar and injury may occur. ○ Always refer to your HiKOKI Authorized Service Center 9. Never remove any of the safety devices equipped on for all repairs.
  • Page 11: Caution On Lithium-Ion Battery

    3. If you fi nd rust, foul odor, overheating, discolor, CAUTION ON LITHIUM-ION BATTERY deformation, and/or other irregularities when using the battery for the fi rst time, do not use and return it to your To extend the lifetime, the lithium-ion battery equips with supplier or vendor.
  • Page 12: Specifications

    Charging not included complete (Continuous buzzer NOTE sound: about 6 sec.) Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to ON/OFF at 0.3 sec. Overheat Battery overheated. change without prior notice. intervals (RED) standby Unable to charge.
  • Page 13: Mounting And Operation

    How to make the batteries perform longer. overheat, reducing the charger’s performance. (1) Recharge the batteries before they become completely ○ If the cooling fan is not operating, contact a HiKOKI exhausted. Authorized Service Center for repairs. When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery.
  • Page 14: Installing (Replacing) Saw Chain

    3. Engaging the new saw chain in the sprocket ○ If the chain oil supplied runs out, use HiKOKI chain oil (Fig. 10) sold separately or equivalent chain oil on the market.
  • Page 15: Remaining Battery Indicator

    The battery remaining power is 25%–50%. If you have any concern regarding the chain brake Lights ; operation, request repair from your HiKOKI Authorized The battery remaining power is less than Service Center. 25%. The chain brake is an emergency stop device that stops Blinks ;...
  • Page 16: Sharpening Of The Chain Blade

    NOTE CAUTION Refi ll the oil tank early to prevent the unit running out of ○ Ensure the guide bar does not become bound in the log oil. by pressure. ○ When working on inclined ground, be sure to stand on 1.
  • Page 17: Maintenance And Inspection

    1. Blade sharpening 2. Cleaning the side cover and sprocket (Fig. 38) Use a 4 mm diameter round fi le. Clean and remove any swarf or dust left inside the The round fi le should be held against the chain blade parts.
  • Page 18: Troubleshooting

    Prolonged storage (3 months or more) of batteries with Important notice on the batteries for the HiKOKI a low charge may result in performance deterioration, cordless power tools signifi cantly reducing battery usage time or rendering Please always use one of our designated genuine the batteries incapable of holding a charge.
  • Page 19 (10"/12") (10"/12") CS3625DC (NN) CS3630DC (NN)
  • Page 20 6697724 90PX-040X (3/8 × 10") 90PX-045X (3/8 × 12") 6698582 379897 104MLEA041 (10") 124MLEA041 (12") 10": 379896 12": 380067 10" : 379898 BSL36..18 12": 377207 957681 UC18YSL3 (14.4 V–18 V) 6698688 329897...
  • Page 24 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99748511 G Printed in China...

This manual is also suitable for:

Cs 3630dcCs3630dch4z

Table of Contents