Cleaning The Device - Dometic OVN0250 Installation And Operating Manual

Cleaning the device

➤ Close the valve on the gas cylinder that is to be replaced.
➤ Unscrew the pressure reducer from the empty cylinder and remove the cylinder.
➤ If a flexible gas connection hose is used:
Check the condition of the hose line. Replace the hose line if the material is brittle
or porous.
➤ Position the new cylinder vertically.
➤ Check that the valve on the gas cylinder is closed.
➤ Tightly screw the pressure reducer by hand onto the new gas cylinder.
➤ Open the main shut-off valve.
!
WARNING!
Never check for leaks with an open flame or near sources of ignition.
➤ Check all the connections for leaks with a leak detection spray or a non-corrosive
liquid. Do not use soapy water.
✔ There are no leaks if no bubbles form.
➤ Ignite the burners and check the operation.
➤ Close the main shut-off valve after checking operation.
➤ Close the valve of the gas cylinder in the event of a malfunction and contact
Customer Service.
8 Cleaning the device
!
WARNING!
• Always disconnect the device from the energy supply before you
clean it.
• Close the main shut-off valve of the gas supply before cleaning the
device.
!
CAUTION! Beware of burns
Allow the device to cool down before cleaning it.
22
OVN0250, OVG0250
EN