Installing The Device - Dometic OVN0250 Installation And Operating Manual

OVN0250, OVG0250
6

Installing the device

!
WARNING! Risk of serious injury
• This device may only be connected to the gas supply by a qualified
specialist in accordance with the applicable guidelines and stand-
ards (in particular EN 1949).
• This device must be connected to a flue with an outlet pipe to
discharge the combustion gases (see chapter "Oven ventilation
using a roof flue" on page 14).
• The installation area must have air vents with an open cross-section of
at least 150 cm
in use, even if they can be closed.
• Before installation check whether the local gas supply (type of gas
and pressure) is compatible with the specifications of the device. The
regulatory requirements of this device are specified on the label (or
type plate).
6.1 Selecting the installation location
When selecting the installation location, observe the following instructions:
• The device must not be installed in potentially explosive environments.
• Select a well-ventilated location for the device.
• Observe the minimum clearance to the top of the horizontal wall and to the
vertical adjacent wall (fig. 3, page 4).
• Observe the installation dimensions for the device (fig. 3, page 4) and for the
flue with the outlet pipe (fig. 4, page 5).
EN
2
. The air vents must be kept open when the device is
Installing the device
13